Flow sensor lobe 1/2 "HP
In Stock
72 $
A petal-like normally open flow sensor with 1/2" NR is used to detect the presence of flow in the filtration pipe.
There is the ability to adjust the length of the petal in 5 mm increments.
Petals material: Polypropylene
Petals lining: Santoprene
Installation instructions:
- Carefully check the orientation of the petal. The arrow on the housing should be exactly parallel to the pipe and match the direction of the water flow.
- There should be a gap of at least 5 mm between the end of the petal and the pipe wall.
Material
Gasket material
Santoprene
Petal material
Polypropylene
Body material
Armlen
Electrical parameters
Protection class
IP 65
Electrical connection
cable 2 × 0.75 mm², PVC insulation
Filtration
Nominal pressure
1 bar
Maximum pressure
2 bar